The module for blocks management Magneti Marelli installed on petrol cars of concern VAG (Audi/Seat/Skoda/VW).
Magneti Marelli IAW 7GV (FID: 5)
This block is used for cars of concern VAG engines 1.4/1.6 CFNA, CFNB, CLRA, CLPA, CLPB, CLSA, CGGB. Supported read full flash and write field calibration via diagnostic connector, as well as correction of the checksum when writing.
The control unit Magneti Marelli IAW 7GV powered by a processor Infineon SAK-XC2785X-104F80L with internal flash memory 832Кб.
The recording is done only in the area of calibrations, thereby reducing the required time to 3 minutes.
Also, the editor calibrations Marelli IAW 7GV.
Magneti Marelli IAW 7GVE (FID: 71)
The control unit Magneti Marelli IAW 7GV is powered by CPU Infineon Infineon SAK-XC2xxx with internal flash memory 832Кб.
Allowed read FullFlash and write field calibration via OBD2.
Supports 1.4 CGGB engines.
Magneti Marelli IAW 9GV (FID: 7)
The control unit Magneti Marelli IAW 9GV is based on the processor NXP SPC5634 with internal flash memory 1.5 MB.
This block is used for cars of concern VAG engines 1.6 CFZA on biofuel. Supported read-write FullFlash in BSL mode, as well as correction of the checksum when writing. Also available for reading and writing EEPROM, which allows to use the module for a complete clone of the ECU.
To operate the unit to open and connect on the table according to the instructions.
Attention! Marelli 9GV works with a limited number J2534 adapters. Currently tested and guaranteed to work CarDAQ Plus, Bosch VCM2, Mongoose.
Also, the editor calibrations Marelli IAW 9GV.
Magneti Marelli IAW 4HV (FID: 17)
This block is used for cars of concern VAG petrol engines 1.4 BUD, BXW, CGGA, CGGB. Supported read full flash and write field calibration via diagnostic connector K-line, as well as correction of the checksum when writing.
The control unit Magneti Marelli IAW 4HV runs on processor ST10F296 internal address space of 832 KB.