Mazda Denso SkyActiv-G

Module to calibrate the firmware of the control units Mitsubishi petrol cars Mazda engine SkyActiv-G 1.3, 1.5, 2.0, 2.5 liters.

Editable the following cards:

The pressure in the rail for direct injection, the estimated temperature of the EXHAUST gas phase of the intake and exhaust shafts, the enrichment in the control mode and power mode, the threshold pedal position to switch to power mode, the request is the throttle position, the load limit, the query time for partial and full loads, rpm, XX, maximum rpm XX rpm XX in the purge mode of the catalyst, the minimum advance angle, reference angle for high/low octane fuel, injection angle, limiting engine speed, the speed limit of the car (only if it is found, FOR the QUERY SPECIFY a SPEED CUTOFF/RESTORE)mask errors.

Urgent request for this module is not available.

Driver usb key

The Program BitEdit

For technical support:

• E-mail: support@bitbox.ru
• Skype: Bitbox.ru

Manual activation modules BitEdit:

1. Install the driver software for usb key and the program BitEdit.
2. Insert the key into a PC, run the program, Bitedit.
3. Let us know the serial number of your dongle (Dongle ID) indicating the number of your order info@ecupro.ru
4. After you receive activation notification, run the program, BitEdit on a PC with Internet connection.

Write review