Honda Moto Keihin

• Axis conversion curves: engine load, engine speed, throttle position
• Engine speed limitation (ON REQUEST)
• Desired idle speed, idle speed regulator parameters
• Injection time in closed / open loop, injection time correction, lambda to switch between open / closed loop
• Lambda regulation maps
• Spark advance base maps, spark advance at idle, spark advance in limp mode
• Start engine speed
• Warm up factors for injection time
• DTC TABLE is not supported for this file type
• Part of the maps may not be found for some files!

• All maps are presented in 2 modes (Normal, Sport).
• Axis conversion curves: engine load, engine speed, throttle position
• Engine speed limitation
• Flaps close/open engine speed
• Injection time by engine load, injection time by throttle position
• Modes switch for engine load or TPS injection maps switch by throttle position
• Scalings for sensors
• Spark advance base, spark advance at full load, spark advance at idle, spark advance correction by in coolant temperature, spark advance at neutral gear/clutch
• Steering damper control
• Vehicle speed limit (on REQUEST)
• Flags (added on REQUEST): O2 sensor enabled flags, O2 heater enabled flags, immobilizer enabled flag, flaps operation enabled flags
• DTC TABLE is not supported for this file type

• Axis conversion curves: engine load, engine speed, throttle position
• Engine speed limitation
• Injection time by engine load, injection time by throttle position
• Spark advance at idle, spark advance in limp mode, spark advance base by gear
• Desired throttle position in normal, sport, sport+ modes
• Vehicle speed limitation
• Flags (on REQUEST): O2 sensor enabled flags, O2 heater enabled flags, immobilizer enabled flag
• DTC TABLE available

• Axis conversion curves: engine load, engine speed, throttle position
• Engine speed limitation
• Injection time by engine load, injection time by throttle position
• Spark advance at idle, spark advance in limp mode, spark advance base by gear, gear switches to select maps
• Desired idle speed
• Modes switch by throttle position for injection time maps selection
• Vehicle speed limitation
• FLAGS-in development
• DTC TABLE is available

Driver usb key

The Program BitEdit

For technical support:

• E-mail: support@bitbox.ru
• Skype: Bitbox.ru

Manual activation modules BitEdit:

1. Install the driver software for usb key and the program BitEdit.
2. Insert the key into a PC, run the program, Bitedit.
3. Let us know the serial number of your dongle (Dongle ID) indicating the number of your order info@ecupro.ru
4. After you receive activation notification, run the program, BitEdit on a PC with Internet connection.

Write review