FID: 91, 94, 96, 97, 98, 99, 100, 102
Module to read and write via the diagnostic connector on the CAN bus control unit ACDelco Gen1 installed on petrol cars of GM (Opel, Chevrolet, etc.).
ACDelco GM E38 (FID: 96)
The control unit is based on the processor Motorola MPC561 external flash memory 2.0 Mb.
Allows reading FullFlash and write field calibration via CAN-bus with correction checksums.
Read/write takes about 3-5 minutes!
GM ACDelco E39 (FID: 100)
The control unit is based on Motorola MCU MPC5566 with internal flash memory of 3.0 Mb.
Allows reading FullFlash and write field calibration via CAN-bus with correction checksums.
Read/write takes about 3-5 minutes!
GM ACDelco E39A (FID: 97)
The control unit is based on Motorola MCU MPC5566 with internal flash memory of 3.0 Mb.
Allows reading FullFlash and write field calibration via CAN-bus with correction checksums.
Read/write takes about 3-5 minutes!
ACDelco GM E67 (FID: 99)
The control unit is based on the Motorola MPC565 processor with external flash memory, 2.0 Mb.
Allows reading FullFlash and write field calibration via CAN-bus with correction checksums.
Read/write takes about 3-5 minutes!
ACDelco GM E78 (FID: 94)
The control unit is based on Motorola MCU MPC5566 with internal flash memory of 3.0 Mb.
Allows reading FullFlash and write field calibration via CAN-bus with correction checksums.
Read/write takes about 3-5 minutes!
ACDelco GM E80 (FID: 102)
The control unit is based on the processor Motorola MPC5676 with internal flash memory 6.0 Mb.
Allows reading FullFlash and write field calibration via CAN-bus with correction checksums.
ACDelco GM E83 (FID: 91)
The control unit is based on the processor Motorola MPC5565 with internal flash memory, 2.0 Mb.
Allows reading FullFlash and write field calibration via CAN-bus with correction checksums.
Read/write takes about 3-5 minutes!
GM ACDelco E92 (FID: 98)
The control unit is based on the processor NXP SPC5674 with internal flash memory of 4.0 Mb.
Allows reading FullFlash and write field calibration via CAN-bus with correction checksums.
Read/write takes about 3-5 minutes!
New block types will be added to this module possible.
Program and driver BitBox usb key 
For technical support:
Manual activation modules BitBox:
-
Install the driver software for usb key and the program BitBox.
-
Insert the key into a PC, run the program BitBox.
-
Let us know the serial number of your dongle (Dongle ID) and the number of your order info@ecupro.ru
-
After you receive activation notification, run BitBox on a PC with Internet connection.
We have fast worldwide delivery by EMS-post
We provide a guarantee for products and technical support
Our system of discounts and regular promotions save your money
