The module is designed to work with the ECU, DSG and CVT. Supported entry for 'OBD' (the main purpose of tuning), as well as work in BOOT mode (the main purpose - to repair) - read and write memory of a processor and external eeprom. For BOOT mode uses a direct connection to the transaxle connector, but without opening the ECU. It is possible to clone the ECU. Work on the HBS supported for UDS variants of the ECU.DQ200 (0AM) [WR/CK]
DQ500 - 0BT/0BH (not 0DL!) only OBD reading when using a direct connection
VL300/V30 - BSL - all OBD - except KW1281
VL381 - all
DL501 - all
Work on OBD: as usual with other packages, no peculiarities, in case of interruption of the recording, you can disable the ignition, then just write it down. In case of 'Uval' a bad tune can 'raise' to BOOT.
Work BOOT: use a direct connection to the connector of the control UNIT, the switching power supply is carried out either manually or (HIGHLY recommended) by using the scheme of automatic power control, powered by L-line (same box Powerbox or converted from KESS). In the case of manual control the entrance to the booth mode can not happen on the first try.
Read DQ500: Only when connecting directly! Caution: the power supply must be switch manually to turn on / off you only need the ignition (pin 15), the second contact needs to be connected constantly!
Do not create new requests. Don't move the key to other PC before the end of activation. After you receive from us file-the updates are inserted in GRDTRU and be sure to send us the latest FILE-response.
After this, log into the settings of the program PCMflash and paste a special code that you send, click Activate. After restarting the program can be used. The key can be used on any PC.
Instructions for the second and subsequent activations of the modules PCMflash:
Make an order for the modules you require in the 'order only If the activation of the modules' indicate the serial number of your USB key PCMflash. The file request from GRDTRU send is not necessary.
After you receive activation code you must enter in the program settings PCMflash and paste this code then click Activate. After restarting the program can be used.