A special service module for real reading on the table of Toyota Denso Gen2 CAN control units.
Allows identification of the software in the block, and also performs a real FullFlash reading over the CAN bus.
It only works with the Scanmatik 2 Pro adapter, to connect the unit, you need to use an adapter with automatic power management and a Boot pin. Opening the block is not required.
Supported MCUs:
-
D76F0199GD 1280Kb
-
D76F0196F1 1536Kb
-
D76F0198F1 1536Kb
-
D76F0219F1 2048Kb
Reading time:
-
With a known password - 8-17 minutes
-
With an unknown factory password - 35-70 minutes
The pre-order discount is valid until 30.09.2024.
