1. The Module 87 DCM6.2 PSA has been added, designed to work with the 2.0L Delphi DCM6.2A/DCM6.2C diesel engine ECU installed on PSA group cars via the diagnostic connector. Supports reading, writing, checking and correcting checksums:

 

2. Module 23 "Subaru Denso" has added support for the ECU of Outback/Legacy vehicles with 2.5L engines 2019-2021 for the US market:

3. The module 42 "Denso SH705x Bootloader" has added support for the ECU of Volvo vehicles using SH7055 microcontrollers.

 

4. In the module 47 "Mitsubishi Gearbox CAN-bus" the problem with reading "TC-SST Getrag 6DCT470" has been solved.

 

5. In module 53 "Infineon Tricore BSL", the ability to read the password of the ME17.9.1 ECU has been added.

 

6. In the module 58 "VAG DSG/CVT", the problem with reading some variants of CVT VL381 has been solved, and the ability to work with a rare variant of DSG DQ500 0BH927711F from 0DL300011C/D/H software used on Passat B8, Audi RS Q3 cars has been added. Virtual reading, writing, checking and correction of CS is supported.

 

7. In the module 71 "Bosch MEDC17 Bootloader", the work with the ME17 ECU has been improved.3.0, EDC17C84.

 

8. The module 76 "Kia/Hyundai Gearbox" has improved support for the SIM2K-305 ECU.

 

9. Support for Kawasaki ECU with MH8610F/MH8611F microcontroller has been added to the module 79 "Mitsubishi CAN-bus Bootloader".

 

10. The module 80 "Denso SH725xx/1N83M Bootloader" has added support for the Subaru ECU with the SH72543 microcontroller.

 

11. JLR Gearbox module 81 has added support for working with TCM ZF 9HP48, supports reading and writing software and EEPROM via the diagnostic connector, as well as the ability to read and write calibrations of TCM ZF 8HP45/8HP70 (cars with FlexRay bus):