CFMoto Bosch ME(D)17.8.10

Brand: BitEdit
Product Code: CFMoto Bosch ME(D)17.8.10
Activate in 24 hours (usually 1-2 hours)
$248.41
Reward Points: 100
Why do professionals
choose ECU Pro?
We have fast worldwide delivery by EMS-postWe have fast worldwide delivery by EMS-post
We provide a guarantee for products and technical supportWe provide a guarantee for products and technical support
Our system of discounts and regular promotions save your moneyOur system of discounts and regular promotions save your money
Module for calibration of firmware of Bosch ME control units(D)17.8.10, used in CFMoto motor vehicles.
 
The following calibrations are available for editing:
Air Control: Accelerator pedal map
Boost limiters: Boost limitation by coolant temperature, Boost limitation from engine speed, Boost limiter to prevent overspeed
Exhaust gas model: Exhaust gas temperature, Exhaust gas temperature 2 Idle speed: Desired idle speed, Desired idle speed MT, Desired idle speed with A/C, Desired idle speed with A/C in drive
Injector control: Injection end timing 1, Injection end timing 2, Injector dead time, Injector flow constant
Knock control: ignition advance angle, Knock retardation step for spark advance, Knock sensor sensitivity factor cyl 1, Knock sensor sensitivity factor cyl 2, Knock sensor sensitivity factor cyl 3, Knock sensor sensitivity factor cyl 4, Minimal ignition angle, Retardation recovery
Limiters: Engine speed limitation 1, Engine speed limitation 2, Engine speed limitation 3, Engine speed limitation by oil temperature, Vehicle speed limiter (if found, not guarantee)
Spark advance: Optimal spark advance
Switch operating modes: Requested torque threshold to detect full load
Target lambda: Delta correction for lambda adaptation, Target lambda at part load, Target lambda at warm up in closed loop, Target lambda for component protection, Target lambda in acceleration request
Throttle: Air mass flow through throttle valve, Desired throttle angle
Torque limitation: Allowed torque from accelerator pedal cold engine in monitoring, Allowed torque from accelerator pedal in monitoring, Offset tolerance for allowed torque 1, Offset tolerance for allowed torque 2, Engine speed dependent torque 1, Engine speed dependent torque 2, Maximal allowed torque 1, Maximal allowed torque 2
Torque model: Driver requested torque base sport 1, Driver requested torque base sport 2, Driver requested torque base sport 3, Driver requested torque base sport 4, Driver requested torque base sport 5, Driver requested torque reverse, Optimal indicated torque, Relative drive desire torque from driving pedal - ECO, Target air filling calculated form indicated torque, Ignition angle efficiency, Lambda efficiency, Minimal defined efficiency
DTC mask

Driver usb key

The Program BitEdit

For technical support:

Manual activation modules BitEdit:

  1. Install the driver software for usb key and the program BitEdit.
  2. Insert the key into a PC, run the program, Bitedit.
  3. Let us know the serial number of your dongle (Dongle ID) indicating the number of your order info@ecupro.ru
  4. After you receive activation notification, run the program, BitEdit on a PC with Internet connection.

Write a review

Your Name:


Your Review:

Rating: Bad           Good



Write review

add to cart

Shopping cart
 
2014-2022 Equipment for car diagnostics and chip-tuning, tools and equipment for auto service - ECU Pro ©
Home Info Account WhatsApp
0
Cart