Continental GPEC (SIM90)

Module for the calibration control systems for gasoline engines Chrysler/Dodge/Jeep with the control units Continental GPEC (SIM90) processor-based Motorola MPC561 external FLASH memory 2Mb.

The following calibration: Volumetric efficiency, mass flow through an orifice the mass flow limiters, the maximum power of the engine and correction of power control XX in different modes, the fuel supply, the composition of the mixture, power enrichment, and correction during warm-up, control of the injection delay time of the nozzles, performance and adjustment pressure for the injectors, the request power for the pedals, the throttle, the corners of the ignition timing in different modes, rebounds upon detonation, the sensitivity of the knock sensors and the Rev limit and speed (where found). Also available for editing mask errors.

For this module, not available in URGENT request to add descriptions.

To read and write data control units via the diagnostic connector You can use the module BitBox Chrysler/Dodge/Jeep Petrol CAN.

Driver usb key

The Program BitEdit

For technical support:

• E-mail: support@bitbox.ru
• Skype: Bitbox.ru

Manual activation modules BitEdit:

1. Install the driver software for usb key and the program BitEdit.
2. Insert the key into a PC, run the program, Bitedit.
3. Let us know the serial number of your dongle (Dongle ID) indicating the number of your order info@ecupro.ru
4. After you receive activation notification, run the program, BitEdit on a PC with Internet connection.

Write review