Bosch MD1

• Control air mass: expected mass air flow correction flow
• Pressure boost: the desired boost pressure, the limit boost pressure, PWM boost controller and its limits
• DPF: mask of regeneration, flags disable DPF sensor calibration back pressure of the EXHAUST gas, flags, and voltage for error detection
• EGR: the EGR position correction lower/upper thresholds to enable the EGR in all modes, the maximum EGR position
• Sensors EXHAUST gas temperature: calibration of all sensors EXHAUST gas temperature, the thresholds of error detection for voltage flags
• Injection: the opening time of the injectors, the calculation of the mass vpriska of time post-injection, the start angle of the main injection and restriction
• The pressure in the rail: components of the PID controller, the set pressure in the rail, the limit pressure, the minimum pressure for starting, the pressure regulator in the rail
• SCR (Adblue): fill/clearing flags for NOx, ADblue injection, lambda control, NSC, LamCtl
• The composition of the mixture: the composition of the mixture to limit the smoke
• Torque limit: the main constraints of input and output torque, limiting torque in case of errors, limiting time in the temperature of the EXHAUST gas, fuel, and backpressure
• Request time: the request time card calculation pedal for modes ECO, Sport, Sport+, reduced the requested time for the coolant temperature and atmospheric pressure
• Mask errors

Driver usb key

The Program BitEdit

For technical support:

• E-mail: support@bitbox.ru
• Skype: Bitbox.ru

Manual activation modules BitEdit:

1. Install the driver software for usb key and the program BitEdit.
2. Insert the key into a PC, run the program, Bitedit.
3. Let us know the serial number of your dongle (Dongle ID) indicating the number of your order info@ecupro.ru
4. After you receive activation notification, run the program, BitEdit on a PC with Internet connection.

Write review