Pre-order for the new Bitbox module
A special service module for real reading on the table of Toyota Denso Gen2 CAN control units.
 
Allows identification of the software in the block, and also performs a real FullFlash reading over the CAN bus.
 
It only works with the Scanmatik 2 Pro adapter, to connect the unit, you need to use an adapter with automatic power management and a Boot pin. Opening the block is not required.
 
Supported MCUs:
  • D76F0199GD 1280Kb
  • D76F0196F1 1536Kb
  • D76F0198F1 1536Kb
  • D76F0219F1 2048Kb
Reading time:
  • With a known password - 8-17 minutes
  • With an unknown factory password - 35-70 minutes
 
The pre-order discount is valid until 30.09.2024.


2014-2022 Equipment for car diagnostics and chip-tuning, tools and equipment for auto service - ECU Pro ©
Home Info Account WhatsApp
0
Cart