VAG Marelli Petrol

Brand: BitBox
Product Code: VAG Marelli Petrol
Activate in 24 hours (usually 1-2 hours)
$116.28
Reward Points: 50
Why do professionals
choose ECU Pro?
We have fast worldwide delivery by EMS-postWe have fast worldwide delivery by EMS-post
We provide a guarantee for products and technical supportWe provide a guarantee for products and technical support
Our system of discounts and regular promotions save your moneyOur system of discounts and regular promotions save your money
The module for blocks management Magneti Marelli installed on petrol cars of concern VAG (Audi/Seat/Skoda/VW).
 
Magneti Marelli IAW 7GV (FID: 5)
 
This block is used for cars of concern VAG engines 1.4/1.6 CFNA, CFNB, CLRA, CLPA, CLPB, CLSA, CGGB. Supported read full flash and write field calibration via diagnostic connector, as well as correction of the checksum when writing.
The control unit Magneti Marelli IAW 7GV powered by a processor Infineon SAK-XC2785X-104F80L with internal flash memory 832Кб.
The recording is done only in the area of calibrations, thereby reducing the required time to 3 minutes.
Also, the editor calibrations Marelli IAW 7GV.
 
Magneti Marelli IAW 7GVE (FID: 71)
 
The control unit Magneti Marelli IAW 7GV is powered by CPU Infineon Infineon SAK-XC2xxx with internal flash memory 832Кб.
Allowed read FullFlash and write field calibration via OBD2.
Supports 1.4 CGGB engines.
 
Magneti Marelli IAW 9GV (FID: 7)
 
The control unit Magneti Marelli IAW 9GV is based on the processor NXP SPC5634 with internal flash memory 1.5 MB.
This block is used for cars of concern VAG engines 1.6 CFZA on biofuel. Supported read-write FullFlash in BSL mode, as well as correction of the checksum when writing. Also available for reading and writing EEPROM, which allows to use the module for a complete clone of the ECU.
To operate the unit to open and connect on the table according to the instructions.
Attention! Marelli 9GV works with a limited number J2534 adapters. Currently tested and guaranteed to work CarDAQ Plus, Bosch VCM2, Mongoose.
Also, the editor calibrations Marelli IAW 9GV.
 
Magneti Marelli IAW 4HV (FID: 17)
 
This block is used for cars of concern VAG petrol engines 1.4 BUD, BXW, CGGA, CGGB. Supported read full flash and write field calibration via diagnostic connector K-line, as well as correction of the checksum when writing.
The control unit Magneti Marelli IAW 4HV runs on processor ST10F296 internal address space of 832 KB.

Program and driver BitBox usb key

For technical support:

Manual activation modules BitBox:

  1. Install the driver software for usb key and the program BitBox.
  2. Insert the key into a PC, run the program BitBox.
  3. Let us know the serial number of your dongle (Dongle ID) and the number of your order info@ecupro.ru
  4. After you receive activation notification, run BitBox on a PC with Internet connection.

Write a review

Your Name:


Your Review:

Rating: Bad           Good



Write review

add to cart

Shopping cart
 
2014-2022 Equipment for car diagnostics and chip-tuning, tools and equipment for auto service - ECU Pro ©
Home Info Account Chat
0
Cart